Architect's Specifications
Furnish and install mop receptor as manufactured by Florestone Products Co.
Shoulder shall be not less than 8" high inside and not less than 1¾" wide.
Drain body shall be brass, cast integral and shall provide for a non-caulked connection (lead caulked optional) not less than one inch deep to a two or three inch pipe (specify 2" or 3").
Mop sinks with 3" drains are supplied with a Wedge-Lok® seal for use on ABS pipe only.
Receptor shall be manufactured of tan and white marble chips cast in white portland cement to produce a compressive strength of not less than 3000 PSI, seven days after casting.
Terrazzo surface shall be ground and polished with all air holes and/or pits to be grouted and excess removed and sealed to resist stains and moisture.
Receptor will be reinforced with 16 gauge wire.
Stainless steel grid standard.
| Note |
 |
|
Specify 2" or 3" drain size (3" standard).
|
|
|
Shown: Model 5
 |
| Model 5 |
Click Image to Enlarge
Dimensions may vary ± ¼ inch.
Please check unit before installation.
|
